ANALOG - (PRE-PROGRAMMED)

For a function to be monitored on the V-Net the signal from that function must pass through two components, a sensor and a module. The sensor is the unit that actually measures the input from the function (ie: pressure, temperature, movement, RPM), while the modules serves the purpose of converting and ‘conditioning’ the signal from the sensor so it can be transmitted over the V-Net cable. Although they can be purchased separately, for your convenience we have assembled a selection of sensors and modules that are commonly used in conjunction with each other. These module/sensor assemblies are pre-programmed for the uses indicated. They are ready to plug & play.

The following modules are equipped with sensors for analog functions. For digital functions please see V-Net Modules with Sensor, Digital.

If a module/sensor combination for your application is not shown below you might want to check out the combo sets that have not been pre-programmed, V-Net Modules with Sensors, Analog (Not Pre-Programmed)

V-Net Module with Sensor, Analog

Note: the EGT junction box sets are ordered by the cylinder back sequence they serve.

Thermocouple lengths are 18”, 23”, 28”, & 33”. Cable from junction box to V-Net module is 36” in length.